change depth scale in reefmaster sonar viewer

Automatically switches the scanning beam to Narrow (7°) when scanning shallow waters with depths below 2m / 4 ft.

Shallow mode – available for CHIRP models only. Night Fishing mode activates a blinking light that is only visible through a transparent cover. With the Deeper START it can be activated immediately, whereas with the Deeper PRO, PRO+ and CHIRP models you will need to replace the standard cover with a Deeper Night Fishing Cover first. The Night Fishing feature should be turned on when fishing at night or in low light conditions. Alongside the Classic color palette, there are two other options – Day and Night - which can be used for the best viewing of your sonar readings in either bright sunny conditions (Day mode) or low light conditions (Night mode). This feature will only work if Fish icons are enabled.Ĭolor palette – allows you to choose the most convenient color palette for viewing your sonar data based on the environment, conditions and the time of day you are fishing. This feature will only work if Fish icons are enabled.įish alarm – enable fish alarms, that will make a sound alarm whenever a fish is detected. You can choose the distance from surface to the fish (Fish icon with arrow up) or distance from the bottom to the fish (Fish icon with arrow down). Show depth – enables or disables depth readings that are displayed above or below fish icons. This feature will only work if Fish icons are enabled. Selecting L/M/S will result in all 3 sizes being shown, L/M will show only large and medium sized fishes, while L setting will show only large fishes. You can choose which size to show by adjusting the slider. Show fish icons – turn on/off special algorithms that interpret fishes and mark them with fish symbols on the screen.įish size – When Fish Icons are enabled, allows you to choose which fish size to show (Large/Medium/Small). We recommend starting from 100% sensitivity and then gradually decreasing sensitivity until you get the best results. If the sensitivity is set too low, the display will not show a lot of sonar returns that could be fish. Decreasing the sensitivity eliminates clutter from the display, which can occur when the water is muddy. When operating in very clear water or at greater depths, you should increase the sensitivity, so you can see even weaker returns that may be of interest. If you use a high sensitivity, the sonar display will show everything, including small baitfish and floating debris in the water. Sensitivity – controls how much detail is shown on the display and can be used to adjust the sensitivity of all sonar frequencies.

This setting is not available for Deeper START Basic sonar display filters out the amount of information and shows only the basic data – bottom structure, depth, fishes.īeam angle – switch between the sonar beam angles of your Deeper sonar. Raw sonar display shows detailed sonar, without any filtering. Sonar display – switch between Raw and Basic sonar display. This setting is not available for Deeper START. You can close the menu at any time by sliding it to the right.įishing mode lets you choose between different fishing modes: Onshore, Boat, Ice fishing, Bait Boat, Show Scan Only, Scan Only (without GPS).

This will open a menu with all available settings for your model of Deeper sonar. Sonar settings can be accessed by clicking the gear icon on the top right corner.

Change depth scale in reefmaster sonar viewer